80014ATS 3kW 14" Immersion Heater

Product Code: 80014ATS

Product Information

 

Key features

– For use in water, in domestic applications
– Single thermostat pocket

Technical data

– Material: Incoloy 800
– Loading: 3kW
– Element diameter: 8mm
– Head size (BSP): 2 ¼”
– Temperature range: Preset temp. 60°C
– Voltage: 240V 1-Phase
– Supplied with thermostat

 

This is a 3kW, 14inch Incoloy Immersion Heater complete with operating rod thermostat (SS11) and separate safety manual reset cut-out. Installed products will carry the Shel-Nibe brand which is part of the Nibe group to which both Shel and Heatrod both belong. The 80014ATS can be used in all standard domestic water areas including normal use in hard water areas susceptible to limescale. If particularly aggressive water conditions are present or the duty/usage is higher than normal then we would recommend a titanium element version which can be priced and manufactured on request.

This immersion heater is most commonly fitted with Shel SS11 thermostat.
See our “Thermostats & Controls” section for more details and to purchase these products.

How to Measure the BSP Thread size of your Immersion Heater:

 

 

£29.23 inc. VAT

In stock

SKU: 80014ATS Category:

Additional information

Head Size (BSP)

Loading (kW)

Voltage (V)

Length (mm/Inch)

Element Diameter (mm)

Sheath Material

Secondary Protection

Stat Inches

Q: Hello Need a quotation for two immersion heaters 3kw 240Volts The number on existing units is AESTB-327 04/14 is this enough information ? Thanks Mike mike.lomax@melchemicals.com
— Asked by Michael Lomax on December 3, 2015
A: Afternoon Mike, thank you for your enquiry, That is a correct model number, It's £36.00 + VAT, please ring if you wish to order this item, Kind Regards, Phil.
Q: Our 80014ATS immersion heater is not working, the resistance of the element is about 20 ohms which seems right. There is a connection through the thermostat. The thermal cut-out is open circuit but the button does not seem to have popped out. Can I replace the cut-out without draining the tank or do I need to get a plumber to replace the whole immersion heater?
— Asked by Richard Carter on October 31, 2016
A: Afternoon Richard, thank you for your question, you can replace the cut out without draining the tank, you just need to unscrew the cut out and replace, Kind Regards, Phil.
Q: Hi, Looking for price for two 80014BTS1.5” replacement immersion heaters for SS cylinder. Assume 1.5 refers to 1 1/2” BST BOSS ? Cannot find reference number on site ! Button stat will not reset on one of the immersions so was going to replace both when drained as they are installed about ten years. Look forward to hearing from you. Regards. John
— Asked by John Doherty on October 9, 2020
A: Yes that is a 1.5'' BSP immersion heater, that part number has been replaced by a DESTB 327. This is not a stock product and is manufactured to order. Please call the office on 0161 727 3713 to order. Kind regards, Hayley
— http://Hayley%20Ashford

Have a Question? Submit it here!

*
*

*